HVM In-Line Water Separators

Housing Features:

HVM provides in-line water separators that are able to remove up to 99 percent of condensate in water effluents. Using an innovative design guide, compressed air is guided to the water separator’s outlet for excellent efficiency. The housings of these separators are made from seawater-resistant aluminum and are anodized for increased corrosion protection for long-lasting durability.

  • Reliably, effectively removes up to 99 percent of condensate.
  • Used upstream of compressed air dryers.
  • Used downstream of aftercoolers or at the point of use.
  • Maximum operating temperature of 140°F.
  • HVM relies on housings made of seawater-resistant aluminum, then anodized to increase corrosion protection.
  • Housing ports match typical dryer and compressor pipe sizes.
  • Filter combinations with/without water separators come with the option of connection kits.
  • Maximum operating pressures -- 232 PSIG (standard) or 725 PSIG (up to two inches)
  • An innovative rectifier design guides compressed air optimally to the water separator’s outlet.
in-line water separator

Flanged Microfilters 1" - 12"
Model Pipe Size (in.) Flow Rate (scfm) Dimensions Maximun
Operating
Pressure		 Weight
(lbs)		 In-Line Water Separators
A B
HVM 0.5T-XX 1/2" 45 2.95 8.27 232 1.87
HVM 1.0T-XX 1" 140 3.94 13.78 232 4.63
HVM 1.5T-XX 1 1/2" 220 5.75 14.37 232 9.04
HVM 2T-XX 2" 530 5.75 22.24 232 13.45
HVM 2.5T-XX 2 1/2" 880 10.24 26.42 232 43.87
HVM 3T-XX 3" 1,325 10.24 35.24 232 57.10
 

Pressure Conversion Factors
Pressure (PSIG) 5 10 14 28 43 57 71 86 100 114 128 148 157 171 186 200 217 232
Correction Factor 0.08 0.18 0.25 0.38 0.50 0.63 0.75 0.88 1 1.13 1.25 1.38 1.5 1.63 1.75 1.88 2 2.13

For maximum flow rate, multiply model flow rate show in the table by correction factor corresponding to the working pressure.